Safety; Safety Instructions - Futurelight GENESIS Série Mode D'emploi

User Manual
GENESIS 575 HMI
FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY
BEFORE YOU INITIAL START-UP!

1. Safety

1.1 Safety instructions

This device has left our premises in absolutely perfect conditon. In order to maintain this condition and to
ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this manual. The manufacturer will not accept liability for any resulting damages caused by
the non-observance of this manual or any unauthorized modification to the device.
This device falls under protection class I. Therefore it is essential to connect the yellow/green conductor to
earth.
The electric connection must be carried out by a qualified employee.
Do not connect this device to a dimmer pack.
For replacement use lamps and fuses of same type and rating only.
1.2 General instructions
Use this projector in closed rooms only.
Do not shake this device. Avoid brute force during operational actions.
For safety reasons unauthorized modifications to the device are forbidden.
You can install this projector at any desired place - as long as you follow the given instructions. Ensure that
the structure to which you attach the projector is secure.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damge your device. Leave the device switched off until
it has reached room temperature.
When taking the device into operation, please make sure that the housing is closed firmly with all the
necessary screws tightened up.
15