A&D Medical UA-1030TCN Manuel D'instructions page 20

Measurements
Measurement with desired Systolic Pressure
Use this method when re-inflation occurs repeatedly even if the pressure
value is set to 240 in the procedure above or when the results are not
displayed even if the pressure decreases to 20mmHg or less.
1. Place the cuff on the arm (preferably the left arm).
2. Press and hold the START button until
a number about 30 to 40mmHg higher
than your expected systolic pressure
appears.
3. When the desired number is reached,
release the START button to start
measurement. Continue to measure
your blood pressure as described on
the E-17.
E-20
At heart level
Press and hold the button
Release the button
at the desired
systolic pressure
Refer to E-17
for measurement
setting mode
START