A&D Medical UA-1030TCN Manuel D'instructions page 10

Using the Monitor
Installing/Changing the Batteries
You must install 4 type A (1.5 volt) batteries (alkaline batteries
recommended), or use the AC Adapter and attach the cuff to the monitor
before using it. To install batteries (or replace them if the "Low Battery"
symbol appears on display), proceed as follows:
1. Remove battery compartment cover by gently pushing down on arrow
and sliding cover forward.
2. Put in bottom row of batteries first. Place the batteries in compartment
with positive (+) and negative
(–) terminals matching those
indicated in the compartment. Be
sure batteries make contact with
compartment terminals.
3. Replace cover by sliding it into the
compartment and gently pressing
into place.
Note: Rechargeable batteries are not recommended
for use with this monitor. Please dispose of batteries
following local regulations.
CAUTION
• Insert the batteries as shown in the battery compartment. If installed
incorrectly, the device will not work.
• When (LOW BATTERY mark) blinks on the display and the device
announces that the battery needs to be replaced, replace all batteries
with new ones. Do not mix old and new batteries. It may shorten the
battery life, or cause the device to malfunction.Replace the batteries two
seconds or more after the device turns off. If
appears even after the batteries are replaced, make a blood pressure
measurement. The device may then recognize the new batteries.
• (LOW BATTERY mark) does not appear when the batteries are
drained.
E-10
Step 1
Step 3
Step 2
(LOW BATTERY mark)