Publicité
Les langues disponibles
Les langues disponibles
EN
1.0
GENERAL INFORMATION
This equipment is a compressed air plasma cutting unit for manual
cutting operations on all conducting materials.
1.1
UNIT COMPOSITION
The equipment, is fitted with:
1.
One 6 meter long 4 x 2.5mm primary cable
2.
One 3 meter long 16 mm secondary cable fitted with a ground
connection
3.
One 5 meter long compressed air pipe
4.
1 equipment operating and maintenance manual
1.2
APPROVED TORCH REFERENCES
- W000401850 - PT130
2.0
DESCRIPTION AND TECHNICAL SPECIFICA-
TIONS
2.1
DESCRIPTION
Figure 1.
Figure 2.
1.
ON/OFF switch
2.
Current/Thickness display
3.
Current adjustment encoder
GENERAL INFORMATION
4.
Reset and mode selection switch
5.
Workpiece connector
6.
Cutting mode indicator light
7.
Restrike mode indicator light
8.
Gouging mode indicator light
9.
Pressure adjustment mode indicator light
10. Fault light
11. Regulator-filter pressure setting
12. Air inlet pipe
13. Power supply cable
14. Torch connector
2.2
DATA PLATE
Three phase supply
Frequency
Effective consumption
Maximum consumption
2 2 2 2
Open circuit voltage
Cutting current
4 4 4 4
Duty cycle 50%
Duty cycle 60%
6 6 6 6
Duty cycle 100%
Protection class
7 7 7 7
Insulation class
Weight
8 8 8 8
Dimensions
European Standards
9 9 9 9
Ingress protection (IP) ratings for electrical enclosures
10 10 10 10
Code letter
3 3 3 3
First number
5 5 5 5
Second number
14 14 14 14
3.0
3.1
The set is delivered in cardboard packaging on a wooden base.
WARNING: THE PLASTIC HANDLES ARE NOT INTENDED
FOR SUSPENDING THE SET. DEVICE STABILITY IS ONLY
11 11 11 11
GUARANTEED ONLY FOR A MAXIMUM INCLINE OF 10°.
3.2
12 12 12 12
The equipment is an automatic multi voltage set. It is delivered
ready to be connected to a 230V or 400V supply.
- Connect the primary cable (4x2.5 mm2 conductors) to a 3-
1 1 1 1
phase + ground socket. (If you need to use an extension ca-
ble refer to chapter 4 «INSTRUCTIONS FOR USE», para-
graph 4.3 «Recommendations for use»).
13 13 13 13
- Check that the fuse sizes correspond with the max. current
consumptions given on page 2.
- Connect your work site or workpiece to be cut to your
ground circuit as explained in the "SAFETY INSTRUC-
TIONS".
3 EN
TECHNICAL SPECIFICATIONS
PRIMARY
SECONDARY
IP
Equipment protection
Protection against solid objected with diame-
2
Protection against vertically falling drops of
1
water, e.g. condensation
Protected against sprays of water up to 60°
3
S
Device standing still during water test
STARTING UP
UNPACKING THE SET
ELECTRICAL CONNECTION
230 V
400 V
50 Hz
15 A
16.5 A
21.2 A
23.3 A
250 V
243 V
20 A ÷ 65A
65 A - 106 V
60 A - 104 V
40 A - 96 V
50 A - 100 V
IP 23 S
H
25 Kg
435 x 235 x 380 mm
EN 60974.1
EN 60974.10
Ø≥
ter
12.5mm
from the vertical
Publicité
