Gong SUP 1 SASU Guide De L'utilisateur page 31

→ Inflation
Inflate your Board with the GONG Pump supplied with your Board. This pump has the
required inflation capabilities, tips and seals compatible with the Valve of your Board.
❶
Choose a soft, clean surface to unroll your
material.
❸
Make sure the Valve knob is in the up position
for the inflation phase. Just press the button
and turn it to the right or left. If you do not
follow this recommendation, the board will
deflate when removing the hose from the valve.
❺
Inflate to the required pressure which should
be between 15 and 20
a small whistling of air at the Pump hose during
inflation. Indeed, the tightness of the pipe is never
perfect, but the losses are insignificant. Likewise,
the Pressure Gauge needle will only begin to
move when the internal pressure of the board
exceeds 5 PSI: it is therefore normal that it does
PSI. It is normal to hear
❷
Open the inflation Valve cap on the front of the
board.
Before proceeding with your first inflation, tighten
the valve with the black key that comes in the repair
kit to insure perfect functioning
in WARNING).
❹
Insert the Pump hose by screwing it in a quarter
turn.
not work from the first strokes Pump.
❻
Once the Board is inflated, disconnect the tip of
the pump, turning it a quarter turn and close the
Valve cap to seal it.
31
GONG-GALAXY.COM
(instructions