Gong SUP 1 SASU Guide De L'utilisateur page 30

H I P E L E A R N
>⃝●
The HIPE
It offers you the performance in terms of stiffness of a rigid board without the
fragility on impact and bulk. But it is not intended for use in competition or rental.
>⃝●
When folding it, do not overtighten your Board along the Carbon Plate.
>⃝●
When navigating, avoid rocky areas or sandbanks. A sudden impact with the
bottom can damage your Board.
>⃝●
In case of loss, do not replace your non-through brass inserts with through
inserts. You risk piercing your Board by screwing your Top Plate onto the Board.
>⃝●
Do not leave sand in the Board's US rails or footstrap inserts.
>⃝●
Observe the pressure recommendations for inflating your Board between 15
and 20 PSI. Do not under-inflate or over-inflate your board.
>⃝●
Do not allow your Board to fall on the ground hard on the Carbon Plate.
Preserve your equipment.
>⃝●
Make sure sand can never get into the Valve or Board. This could cause
damage.
>⃝●
In order to ensure the longevity and the good functioning of your Pump, do
not hesitate to check from time to time the lubrication of the piston inside your
Pump by adding silicone grease if necessary.
>⃝●
Despite all your precautions, and the solidity of the PVC, it is possible that
you manage to pierce your Board on a very sharp rock for example. The
marine grade PVC glue needed for the job can be found at any hardware store or
specialty boat shop.
/ F R E E F L Y
>⃝●
Never leave your Board in direct sunlight. Excessive
temperature can damage the PVC and increase pressure, risk
breaking welds and causing leaks.
>⃝●
After each use, rinse your Board in fresh water with the valve
closed and let it dry before storing it in its bag.
>⃝●
Do not leave your Board inflated for long periods of time. If
you choose not to deflate it for storage, you should still deflate
it slightly (enough to being able to easily sink your thumb in the
board) to lower the pressure in it. Then store it in a clean and dry
place.
is designed for recreational use in SUP foil and Wing foil.
/ P E R F
30
EN