Lotus BM-94EM Instructions Pour L'installation Et L'emploi page 17

Never start up the appliance without water. Bain-Marie are appliances for heating and keeping warm meat, fish,
vegetables, legumes, etc. with the exclusion of fried foods.
The system must be connected to a drinking water supply with the following characteristics. Failure to do so
automatically invalidates the guarantee
Total hardness: 0,5 to 5°F to prevent the build-up of lime-scale
Pressure: 50 to 250 kPa (0,5-2,5 bar).
Chlorine ion concentration (Cl-): not more than 10 ppm (acceptable value) to avoid damaging the internal steel
elements
pH: over 7
Electrical conductivity: 50 to 2000 μS/cm (20°C)
Check that the water drainage tap, which is located in the compartment under the appliance (lever in horizontal
position), is turned off. Fill the tub with water (max.60°C), keeping the button of the filling electrovalve pressed down
until reaching the level indicated by the symbol
appliance. Turn the knob from "0" into the desired position between 30°C and 90°C; the white and green lights come
on. The green light indicates that the power supply is on.
The white light shows that the heating element is working; when the temperature is reached, it goes out. To turn off the
appliance, turn the knob into position "O".
To carry out this operation, it is necessary to open the outlet tap (lever in vertical position) which can only be reached
through the cabinet door situated under the appliance.
Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with high
pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the appliance ensures the perfect
functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water
and neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry
cloth. Do not use abrasive or corrosive detergents.
PROCEDURE TO FOLLOW IF THE APPLIANCE IS NOT GOING TO BE USED FOR
Clean and dry the appliance carefully according to the instructions. Disconnect the power supply.
PROCEDURE TO FOLLOW IN THE EVENT OF A BREAKDOWN
In the event of breakdown, turn off the appliance, disconnect the power supply by using the device situated above the
appliance and notify the after sales service.
MAINTENANCE (ONLY FOR QUALIFIED PERSONNEL)
Any kind of maintenance must only be done by qualified personnel. Before carrying out maintenance, remove the plug
or switch off the switch above the appliance. Empty the tub when it is full.
To get to the junction box, remove the back of the appliance. The control elements are reached from the front panel;
unscrew the black cap of the water drainage lever, unscrew the fixing screws from the panel and then remove it
GB
IT
WATER SUPPLY CHARACTERISTICS
TURNING ON
--
stamped inside the tub. Switch on the switch situated above the
EMPTYING THE TUB
CLEANING AND MAINTENANCE
SOME TIME
ACCESSIBILITY
17
IE
CH