Sony STR-DA5200ES Mode D'emploi page 73

• SIDE/LOW
Select if the location of your surround
speakers corresponds to sections A and C.
• SIDE/HIGH
Select if the location of your surround
speakers corresponds to sections A and D.
• BEHD/LOW
Select if the location of your surround
speakers corresponds to sections B and C.
• BEHD/HIGH
Select if the location of your surround
speakers corresponds to sections B and D.
Tip
Surround speaker position is designed specifically
for implementation of the Cinema Studio EX modes.
For other sound fields, speaker position is not so
critical.
Those sound fields were designed under the premise
that the surround speakers would be located behind
the listening position, but presentation remains fairly
consistent even with the surround speakers
positioned at a rather wide angle. However, if the
speakers are pointing toward the listener from the
immediate left and right of the listening position, the
surround effects become unclear unless set to
"SIDE."
Nevertheless, each listening environment has many
variables, such as wall reflections, and you may
obtain better results using "BEHD" if your speakers
are located high above the listening position, even if
they are located to the immediate left and right.
Therefore, although it may result in a setting
contrary to the above explanation, we recommend
that you playback multi-channel surround encoded
software and select the setting that provides a good
sense of spaciousness and that best succeeds in
forming a cohesive space between the surround
sound from the surround speakers and the sound of
the front speakers. If you are not sure which sounds
best, select "BEHD" and then use the speaker
distance parameter and speaker level adjustments to
obtain proper balance.
Option menu parameters of Auto
Calibration settings
x Speaker Pattern
(Speaker setup pattern)
Selects the pattern number according to the
number of the using speakers.
x Test Tone
(Test Tone)
Lets you output the test tone sequentially from
each speaker.
• OFF
• AUTO
The test tone is output from each speaker.
• FIX
You can select which speakers will output
the test tone.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
x Phase Audio
(Phase audio)
• OFF
• ON
Lets you output front 2 channel source sound
(instead of the test tone) sequentially from
adjacent speakers.
x Phase Noise
(Phase noise)
• OFF
• ON
Lets you output the test tone sequentially
from adjacent speakers.
x Center Mix
(On/off of the analog downmix
settings)
• OFF
If there is no center speaker connected, this
setting is set to "OFF" automatically.
• ON
We recommend you set "Center Mix" to
"ON" to enjoy digital audio with high
quality sound when you do not have a center
speaker connected. Analog downmix works
continued
73 GB