Sony STR-DA5200ES Mode D'emploi page 47

Display Explanation
CODE 34 Speakers are not placed in the
proper position. Speakers or an
optimizer microphone on the
right or left may be placed
wrongly. See "1: Installing
speakers" (page 15) and check
the speaker position.
WARNING 40 The auto calibration has
completed. However, the noise
level is high. You may be able to
perform the auto calibration
properly if you try it again, even
though the measurement cannot
be performed in all environments.
Try to perform the auto
calibration in a quiet
environment.
WARNING 41 The sound input from the
optimizer microphone is outside
the acceptable range. It is louder
than the loudest sound that can be
measured. Try to perform the auto
calibration when the environment
is quiet enough to allow proper
measurement.
WARNING 42 The volume of the receiver is out
of the acceptable range. Try to
perform the auto calibration when
the environment is quiet enough
to allow proper measurement.
WARNING 43 The distance and position of a sub
woofer cannot be detected. Or the
angle of the speaker position
cannot be detected. This may be
caused by noise. Try to perform
the auto calibration in a quiet
environment.
NO WARNING There is no warning information.
---------- No speakers are connected.
•CODE 31
1
Press , then follow the instructions from step
1 of "Performing auto calibration."
•CODE 32, 33, 34
1
When you press , "RETRY?" appears.
2
Press V/v to select "YES," then press
3
Follow the instructions from step 2 of
"Performing auto calibration."
4
Press V/v repeatedly to select preset number to
store preset settings then press
When you select "WRN CHECK"
If a warning on the measurement result is
present, detailed information is displayed.
Press
"Confirming/saving the measurement
results."
Tip
Depending on the position of the sub woofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
.
.
to return to step 1 of
47 GB