9: Calibrating The Appropriate Settings Automatically (Auto Calibration) - Sony STR-DA5200ES Mode D'emploi

9: Calibrating the
appropriate settings
automatically
CALIBRATION)
The DCAC (Digital Cinema Auto Calibration)
function allows you to perform automatic
calibration, such as checking the connection
between each speaker and the receiver,
adjusting the speaker level, and measuring the
distance of each speaker from your listening
position automatically. Refer also to "Quick
Setup Guide" supplied with the receiver.
Before you perform the auto
calibration
Before you perform the auto calibration, set up
and connect the speakers (page 15-18).
• The AUTO CAL MIC jack is used for the
supplied optimizer microphone only. Do not
connect other microphones. Doing so may
damage the receiver and the microphone.
• During the calibration, the sound that comes
out of the speakers is very loud. Pay
attention to the presence of children or to the
effect on your neighborhood.
• Perform the auto calibration in a quiet
environment to avoid the effect of noise and
get a more accurate measurement.
• If there are any obstacles in the path between
the optimizer microphone and the speakers,
the calibration cannot be performed
correctly. Remove any obstacle from the
measurement area to avoid measurement
failure.
• When you use a bi-amplifier connection, set
"Sur Back Assign" to "BI-AMP" in the Auto
Calibration settings menu before you
perform auto calibration (page 74).
Notes
• The auto calibration function does not work in
following cases.
– MULTI IN is selected.
42
GB
(AUTO
– "2ch Analog Direct" is being used (page 111).
– Headphones are connected.
• Cancel the muting if MUTING is set to on.
1
Connect the supplied optimizer
microphone to the AUTO CAL
MIC jack.
2
Set up the optimizer
microphone.
Place the optimizer microphone at your
listening position. Use a stool or tripod so
that the optimizer microphone remains at
the same height as your ears.
On setting up the active sub
woofer
• When a sub woofer is connected, turn on the
sub woofer and turn up the volume
beforehand. Turn the VOLUME knob to just
before the mid-point.
• If you connect a sub woofer with the
crossover frequency function, set the value
to maximum.
• If you connect a sub woofer with an auto
standby function, set it to off (deactivated).
Optimizer microphone