EUROM 333800 Manuel D'utilisation page 24

- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating
duet o wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V~50Hz) and is
grounded.
If everything is all right you can insert the plug into the socket.
The Golden Comfort RC(D) has a remote control that works with two batteries:
AAA, 1.5V. While using, point the remote control to the receiving point of the
heater (on the electric part).
the heater, it will not work! Remove the batteries out of the season, that will
extend the life of the remote control.

Press the on/off switch (1) on the side of the unit to "I" (on). The light of the
reception point (2) will light.

Set the device into operation by pressing the ON button of the remote control.
Golden 1800 Comfort RC

The infrared heater will now start its operation.
Golden 2200 Comfort RCD

The device has a 'slow start' at 33% output (NB. This requires a fuse type C). 4
seconds after starting, it automatically switches to the most recently used
output. On first use, it will switch to 100% output after 4 seconds.

Select the appropriate power level by one of the three buttons:
Low = 33% - Med = 66%
Golden 1800 Comfort RC & 2200 Comfort RCD
To stop the unit, first press the 'off' button on the remote control. Then turn it off
by pressing the on/off-switch to 'O' (off). The light of the reception point (2) will
extinguish. Finally, unplug it from the wall outlet. Allow the heater to cool down.
Warning! When you turn off the unit using only the remote control, the 'standby'
remains. So turn it off using the remote control or the on/off-switch and remove
the plug from the socket!
When you use the appliance for the first time (or after a long time again), observe
it during the first 10 till 15 minutes to be sure that is works trouble-free.
If there are obstacles between remote control and
- High = 100%
24