Publicité
Les langues disponibles
Les langues disponibles
Fault
Error code ":ƒ... is lit.
Error code ":Ġ is lit.
Error code ":ƒˆ is lit.
A different error code is
indicated on the digital display.
(":‹‚ to ":„‹)
Refill indicator for salt P and/
or rinse-aid H is lit.
Refill indicator for salt P and/
or rinse-aid H is not lit.
Water is left in the appliance at
the end of the wash cycle.
Dishes not dry.
Plastic dishes not dry.
Cause
Waste-water hose kinked or
blocked.
Siphon connection still sealed.
Cover on the drain pump loose.
Drain pump blocked or cover on the
drain pump is not locked in position.
Mains voltage too low.
A technical fault has probably
occurred.
No rinse aid.
No salt.
Sensor does not detect salt tablets. Use different special salt.
Refill indicator switched off.
There is still enough special salt/
rinse aid available.
Filter system or area under the
filters 1Z is blocked.
Wash cycle has not ended yet.
No or too little rinse aid in the
dispenser.
Wash cycle selected without drying. Select wash cycle with drying.
Water collecting in depressions on
the dishes and silverware.
The combined detergent used has a
poor drying performance
extraDry to increase drying not
activated.
Dishes were removed too early or
drying process had not ended yet.
The eco rinse aid used has a limited
drying performance.
Special properties of plastic.
Troubleshooting
Remedial action
Install hose without kinks, remove any
residue.
Check connection to siphon and open if
required.
Lock cover correctly.
Clean pump and lock cover correctly.
Not an appliance fault, have the mains
voltage and electrical installation checked.
Switch off appliances with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the error
code.
Refill rinse aid.
Refill with special salt.
Activation/deactivation ~ ", Rinse Aid",
~ "Water softening system / special salt"
Check refill indicator, levels.
Clean filters and area underneath.
Wait until wash cycle ends or reset.
Refill rinse aid.
Arrange dishes in a sloping position,
arrange affected dishes as sloping as
possible.
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Activate extraDry.
Wait until wash cycle ends or wait until 30
min after wash cycle ends before removing
dishes.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic has a lower heat storage capacity
and therefore dries less well.
en-us
39
Publicité
