Publicité
Les langues disponibles
Les langues disponibles
Operating the Dishwasher
1
Note: With hidden controls, the door must be opened
O p e r a t i n g t h e D i s h w a s h e r
before changing settings and closed after changing
settings.
9
WARNING
Risk of injury!
To avoid risk of injury, always use caution when
opening the door during or following a wash cycle
as hot water or steam may escape. Do not fully
open the door until water noises have stopped
and steam has subsided.
Protection against unintentional
operation
Your dishwasher is equipped with a function that helps
to prevent unintentional operation, for example by
children.
After setting the dishwasher the appliance door has to
be closed within 4 seconds, otherwise the operation will
be paused. There will be a signal on the control panel
advising you to press the Start button again and close
the door.
This function will be activated when:
pressing Start to begin a wash cycle
▯
setting Delay time and pressing Start
▯
opening the door while Delay time is active
▯
opening the door during a wash cycle.
▯
Note: This function cannot be deactivated.
Operating the touch buttons
Buttons are sensitive and should be touched gently.
Avoid any grease or food particles resting on the
buttons as they could activate the dishwasher.
Wiping and cleaning can also activate the dishwasher.
For best results, use bare, clean hands when touching
the buttons.
To clean the touch buttons wipe them with a dry or
slightly damp cloth.
Operating the Dishwasher
Opening the door
To open the door, press the upper middle part of the
door. The appliance opens automatically.
If you have activated the child-proof lock, press twice in
quick succession at the upper middle part of the door.
Changing the settings
The dishwasher has been preset with certain settings
for your convenience. You can change these factory
settings.
Change the setting as follows:
1.
Open the door.
Switch on ON/OFF button (.
2.
Press Info button ( 8 for 3 seconds until the
3.
following text is indicated in the digital display @:
Scroll with < >
Set with - +
Leave with t 3 sec.
4.
Keep pressing button > )* until the required setting
is indicated in the digital display @.
Make the selection with setting buttons + - X.
5.
6.
Press and hold the Info button (8 for 3 seconds.
The chosen setting has now been stored.
Tip: If you change several settings, first make all
changes in succession. Now press the Info button (
8 for 3 seconds. This saves all set values in the
appliance.
AquaSensor *
The AquaSensor is an optical measuring device (light
barrier) which measures the turbidity of the rinsing
water.
The AquaSensor is used according to the wash cycle. If
the AquaSensor is active, "clean" rinsing water can be
transferred to the next rinse bath and water
consumption can be reduced by 3–6 litres. If
the turbidity is greater, the water is drained and
is replaced with fresh water. In the automatic wash
cycles the temperature and running time can also be
adjusted to the degree of soiling.
* optional feature which may or may not be included with
your dishwasher
en-us
31
Publicité
