Publicité
Les langues disponibles
Les langues disponibles
en-us
Operating the Dishwasher
Time display
The wash cycle time is determined during the wash
cycle by the water temperature, the amount of dishes, as
well as the degree of soiling and may vary (depending
on the selected wash cycle). You can change the time
display into time of day or hours/minutes so that the
remaining cycle time of the wash cycle appears in the
display window "Ready at" (for example 15:20 o'clock)
or "Ready in" (for example 3:25 hours).
Sensor setting
The wash cycle sequence is optmised in Auto wash
cycles with the aid of sensors. The sensors adjust the
wash cycle strength of Auto wash cycles depending on
the amount and type of soiling. You can adjust the
sensitivity of the sensors in 3 stages.
Standard: This setting is ideal for a mixed load and
heavily soiled utensils, but also saves energy and water.
Sensitive: This setting adjusts the wash cycle strength
for the effective removal of food remnants, even if the
amount of soiling is low. The energy and water
consumption is adjusted accordingly.
Very sensitive: This setting adjusts the wash cycle
strength for difficult conditions of use, for example
firmly dried on food remnants. This setting is
recommended if using biological or eco detergents
which contain lower amounts of active agents. The
energy and water consumption is adjusted accordingly.
extraDry
The final rinse uses a higher temperature which
improves the drying result. The cycle time may increase
slightly. (Caution if utensils are delicate!) You can
switch the extraDry function on or off.
Eco forecast
When Eco forecast is activated, the average water and
energy consumption of the selected wash cycle is
briefly displayed in the digital display @.
AutoPowerOff
(Switching off automatically after the
end of the wash cycle)
To save energy, the dishwasher is switched off 1 minute
after the wash cycle ends. You can also change this
setting.
32
Possible settings are:
off: The appliance does not switch off automatically.
▯
After one minute: The appliance switches off after
▯
1 minute.
After two hours: The appliance switches off after
▯
2 hours.
EmotionLight *
The EmotionLight 1" is on when the door is open
irrespective of whether the ON/OFF switch ( is
switched on or off. When the door is closed, the
EmotionLight is off. You can switch the EmotionLight on
or off.
Note: Note that when the door is open the EmotionLight
is automatically switched off after 1 hour.
* optional feature which may or may not be included with
your dishwasher
Remaining time projection
(Optical display while the wash cycle is
running) *
While wash cycle is running, an optical display
(additional cycle information) is indicated on the floor
under the appliance door. If the base panel is pulled
forwards or if the appliance is installed at eye-level with
flush furniture front, the display is not visible.
You can switch the optical display on or off.
* optional feature which may or may not be included with
your dishwasher
Infolight *
While the wash cycle is running, a light spot shines
on the floor under the appliance door. Do not open the
appliance door until the light point is no longer visible
on the floor. If the appliance door is not completely
closed, the light spot flashes *. If the appliance
is installed at eye-level, with flush furniture front,
the light point is not visible. You can switch the Infolight
on or off.
* optional feature which may or may not be included with
your dishwasher
Changing start wash cycle
You can change the "Start wash cycle" setting.
Publicité
