Unpacking And Inspection; Features - Amprobe AM-420 Mode D'emploi

• Do not apply more than the rated voltage, as marked on the meter,
between the test probes or between any test probe and earth ground.
• Use the meter with caution for voltages above 30 Vac rms, 42 Vac peak, or
60 VDC. These voltages pose electrical shock hazards.
• Disconnect circuit power and discharge all high-voltage capacitors before
testing resistance, continuity and diode.
• Do not use the meter around explosive gas or vapor.
• When using the test leads, keep your fingers behind the finger guards.
• Remove test leads from the meter before opening the meter's case.
• If the meter is used in a manner not specified in the user manual, the
protection provided by the equipment may be impaired.
• To avoid injury, when the "battery low" indicator is present in the display,
the product should NOT be used. A false measurement may occur. The
battery should be replaced immediately.

UNPACKING AND INSPECTION

Your shipping carton should include:
1 AM-420 Multimeter
1 9V alkaline battery (installed)
1 User manual
If any of the items are damaged or missing, return the complete package to the
place of purchase for an exchange.

FEATURES

Residential digital multimeter to check for voltage in receptacles, electrical
circuits, fuses, light bulbs and electrical connections.
• Measurements: Voltage up to 250V AC/DC, DC Current and Resistance
• Special functions: Audible continuity and diode test
• Event: Data hold
• Low battery warning
• Safety: CAT II 250V
WHILE MEASURING
X�
1. Use the proper function and range for measurements.
2. To avoid possible electrical shock, personal injury or damages to the meter,
disconnect circuit power and discharge all high-voltage capacitors before
testing resistance, continuity and diode.
3. Connecting test leads:
• Connect the common (black) test lead to the circuit before connecting the
live lead
• After measurement, remove live lead before removing the common
(black) test lead from the circuit
4. Over-range indication: "1", "-1", or maximum display reading.
4