Publicité
Les langues disponibles
Les langues disponibles
HALOGEN BULBS
This range hood requires two halogen bulbs
(Type T3, 12V, 20Watt max, G-4 Base).
ALWAYS SWITCH OFF THE ELECTRICAL
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Open the cover by prying from the proper
slots. - DO NOT ROTATE. CAUTION: BULB
MAY BE HOT! Fig. 1
2. Replace with a T3, 12V, 20Watt max, G-4
base bulb. Do not touch replacement bulb
with bare hands!
FUSE REPLACEMENT
IF LIGHTS FAIL TO OPERATE, DISCONNECT
THE POWER AT THE SERVICE ENTRANCE.
CHECK THE FUSE AND REPLACE IF
NECESSARY.
1.
Remove the filters.
2.
Locate the control board box and
transformer, positioned up inside the hood.
Fig. 2
3.
Unfasten (4) screws from the control board
box and remove the cover. Fig. 2
4.
Remove the fuse from the control board.
Fig. 2
5.
Replace the fuse with the same size and
amperage (5x20mm, 4amp, 125volt).
6.
Replace the control box cover and secure
with (4) screws.
7.
Reconnect power at the service
entrance.
FUSE
CONTROL
BOARD BOX
- 5 -
FIG. 1
DECORATIVE
FLUE
FIG. 2
Publicité
