Publicité
Les langues disponibles
Les langues disponibles
INSTALL FLUE MOUNTING
BRACKET
1. Assemble the flue mounting bracket,
adjusting outside width as shown. Fig.4
2. Carefully center the mounting bracket
directly over the range hood location.
3. Secure the bracket assembly to the ceiling
using (2) 4.8x38mm mounting screws
and drywall anchors. Make sure the
bracket is pushed into the corner, tight
against the wall and centered over the
hood.
PREPARE THE HOOD
Note: On stainless steel hoods, carefully
remove the plastic protective film from all
exterior surfaces of the hood and decorative
flues, prior to final installation.
1. Locate (2) tabs on top of the hood and inside
the round discharge opening. Fig. 5
2. Fold both tabs up 90 degrees. Fig. 5
3. Install the discharge collar inside the tabs
and secure with (2) 3.9 x 9.5mm screws.
Fig. 5
4. Attach an adequate length of 8" round steel
ducting to the range hood's discharge collar.
Fig. 5
5. Duct tape all joints to make them secure
and air tight.
INSTALL THE HOOD
1. Install the hood into its mounted position.
2. Align the rectangular opening on the back
of the hood with the wall-mounting bracket.
Gently lower the hood until it securely
engages the bracket. Fig. 6
3. Level the hood and secure with (4) mounting
screws (4.8x38mm). Use drywall anchors
provided if wall studs or framing are not
available. Fig. 6
FLUE MOUNTING
BRACKET
8" DUCT
TABS
RECTANGULAR
CUTOUT
MOUNTING
SCREWS (4.8x38)
- 10 -
3.9x6 mm FLAT
HEAD BRACKET
SCREWS
9 3/4"
FIG. 4
DISCHARGE
COLLAR
FIG. 5
MOUNTING
BRACKET
FIG.6
Publicité
