OPERATION
Controls
The hood is operated using the (4) push-
buttons located at eye-level, on the front edge
of the hood.
LIGHT
DISPLAY
SWITCH
RESET
The light switch turns the halogen lights on
SWITCH
and off. Push the light switch once to turn the
TIMER
lights ON - push a second time to turn the
SWITCH
BLOWER
lights ON to a brighter level - push a third time
SWITCH
to turn the lights OFF.
The timer switch turns the blower timer on and off. Push this switch once to turn the
timer ON. With the blower timer turned ON, the speed that was selected will blink in
the display; if the speed selection is changed the blower timer will remain ON; the
blower will shut OFF after 10 minutes.
The display indicates:
- indicates the selected motor speed (from 1 to 4);
- indicates Timer On when the number blinks;
- indicates Filter Alarm when the central segments is on or blinking.
The blower switch turns the blower on and off. Push the switch once to turn the
blower ON (turns on to last speed selected). Pushing the switch sequentially selects
blower speeds from 1 to 4. To turn OFF the blower, push and hold the blower switch
for approximately 2 seconds.
The reset switch resets the grease filter alarm. The grease filter must be cleaned
when the center segment of the display lights up continuously or blinks. The filter
alarm will be seen in the DISPLAY for approximately 30 seconds after the blower is
turned off. To reset the hour counter, keep the switch pressed for 2 seconds when
the alarm can be seen in the DISPLAY.
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original
setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned
OFF. When this occurs, it is impossible to turn the blower OFF with its switch.
If you must stop the blower, do it from the main electrical panel.
- 4 -