WIKA PSD-30 Mode D'emploi page 21

7. Starting, operation / 8. Maintenance, accessories
Manufacturer-specific system commands:
Index
Objekt Name
(decimal)
2 RES
2 LOCK
2 UNLOCK
2 RHL
2 0SET
Functional test
The output signal must be proportional to the pressure. If not, this might point to a
damage of the diaphragm. In that case refer to chapter 9 „Trouble shooting".
Open pressure connections only after the system is without pressure!
„
Observe the ambient and working conditions outlined in section 7
„
„Technical data.
Warning
Please make sure that the pressure switch is only used within the overload
„
threshold limit at all times!
When touching the pressure switch, keep in mind that the surfaces of the
instrument components might get hot during operation.
Caution
8. Maintenance, accessories
WIKA pressure switches require no maintenance.
„
Have repairs performed by the manufacturer only.
„
Accessories: Mounting clamp (Order No. 11467887)
For details about the accessories (e. g. connectors), please refer to WIKA's price list or contact
our sales department.
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio
Value Note
130 Return the set parameter to the Factory Settings
163 Global keylock on
164 Global keylock off
176 Clear the Min- and Max-value memory
177 Zero Point adjustment (3% of span) see page 29
GB
PSD-30 21