Télécharger Imprimer la page

Signature SFDOOR474XNFE Manuel D'utilisation page 64

Publicité

Les langues disponibles

Les langues disponibles

Problem
Door seal fails to be
tight
Water pan
overflows
Hot housing
Disposal
The refrigerating gas contained in the circuit of this appliance
is isobutane (R600a); it causes a low level of pollution but is
inflammable. Please contact your local disposal department for
advice on the correct method of disposal.
Possible reason
Remove foreign matters on the door seal
Heat the door seal and then cool it for restoration (or blow it
with an electrical drier or use a hot towel for heating)
There is too much food in the chamber or food stored
contains too much water,resulting in heavy defrosting
The doors are not closed properly, resulting in frosting due to
entry of air and increased water due to defrosting
Heat dissipation of the built-in condenser via the housing,
which is normal When housing becomes hot due to high
ambient temperature, storage of too much food or
shutdown of the compressor is shut down, provide sound
ventilation to facilitate heat dissipation
Condensation on the exterior surface and door seals of the
refrigerator is normal when the ambient humidity is too high.
Just wipe the condensate with a clean towel.
- 27 -

Publicité

loading