ECOVACS WINBOT W1 PRO Manuel D'instructions page 11

3
Start
①Turn the Power Switch to "I ".
②Attach to the Window.
Method 1: Shortly press on WINBOT, then attach it to the glass.
Method 2: Evenly press WINBOT onto the glass for 3 seconds and more
to make it firmly attached until you hear a voice prompt.
WINBOT will start cleaning after it has attached to the window successfully.
* Do not stick the WINBOT too close to the edge when cleaning the frameless
glass. It is recommended to be more than 10 cm (3.94 in) away from the edge.
* WINBOT can only clean flat surfaces. Please make sure that the glass
thickness is not less than 3 mm (0.12 in).
* Do not put the fan close to hair and other small objects after power on, so as
not to block the fan.
4
Maintenance during Cleaning
For heavily stained glass, please wash or replace the Mopping Pad
several times and clean the four Spherical Sensors in time.
Pause
During cleaning, press
Remove WINBOT
OR
When cleaning is complete, WINBOT will return to the starting position
and beep. Press and hold
the fan stops working.
5
Finish
on WINBOT or pause it via App.
for 5 seconds and more, and remove it after
11
EN