Publicité
Les langues disponibles
Les langues disponibles
5. PANELS MOUNTING
>
Prepare the appliance door for panel mounting by threading the shoulder bolts into the recessed
receivers and the set screws into the other hole [ 7 ]. Ensure the end with the hex key socket is
threaded into the door and not on the visible end. Thread this in far enough that it is flush with
appliance door face so as not to interference with hanging the panel. You will adjust these later.
7
18
Note
Shoulder bolt for hanging brackets on
and for pulling panel in towards the ap-
pliance door.
Note
Set screw used to set depth / z-axis
position of panel and to put opposing
pressure at each fixing point to 'lock'
panel in place.
www.smeg.com
Publicité
