Publicité
Les langues disponibles
Les langues disponibles
3. PREPARING THE INSTALLATION
3.1. Transport to installation site and
unpacking
The appliance is very heavy.
Take maximum care during handling
to avoid injury.
The appliance should always be
transported in an erect position.
Avoid at all costs leaning it on its front side.
2
1
3
Since this is a large and heavy appliance, before
transporting the appliance, check the access to
the location where it will be installed (door size,
maneuvering space in stairwells, etc.).
The appliance is attached to the base of the
packaging (pallet) through four bolts which can be
removed using a 19 mm (3/4") wrench.
It is recommended to use a manual transporting
device to move the appliance to the installation
site, and only at this point to remove the base of
the packaging.
The appliance should always be transported in an
erect position.
If this is not possible, transport the appliance
laying on its rear side.
Once at the installation site, the appliance, which
is equipped with four wheels, can be taken off the
pallet and positioned in the installation area.
Operate as follows:
>
Take off the four bolts securing [ 1 ] the appliance to
the pallet by means of a 19 mm (3/4") wrench or socket.
>
Remove the fixing brackets [ 3 ] and [ 4 ] .
>
To release the front fixing bracket [ 3 ] , loosen
the rear wheel adjusting bolt [ 2 ] by means of a 13
mm (1/2") wrench or socket. Avoid straining this
bolt at its stop points one way or the other so as to
4
1
www.smeg.com
not damage the rear leveling system.
Ensure the front leveling legs are retracted so that
all 4 wheels are able to contact the floor for easiest
maneuvering.
>
From the back of the unit and by means of a
suitable, heavy duty hand trolley, take off the
appliance and place it on the floor.
Be very careful to avoid any damage to floors.
Delicate floors should be protected with plywood,
hard cardboard or similar material panels.
3.2. Electrical and water connection
The Built-in filter cannot make it safe
drink any water which is not already
suitable for human consumption.
The appliance should be connected only
to a potable water supply system.
Do not use extension cords or adapters.
Once the appliance is fully installed,
connected to the water supply (if
applicable) and operational, in the event
that the water supply must be turned off,
(touch the button
disable the ice maker) before the main
water is shut off to prevent the appliance
from entering a 'NO WATER IN' alarm state.
• OVERHEAD VIEW •
E
W
E
W
E
W
ELECTRICAL & WATER
CONNECTION
W
E
Electrical or water connections located
directly behind the appliance must be
recessed. Do not put the water shut-off
valve directly behind the appliance.
It should be in an accessible location.
The appliances are delivered from the factory
for operation at 110V-120V AC - 60Hz (US and
Canada).
They are provided with a suitable supply cable
and plug to be connected to an appropriate 15A
socket providing an effective grounding.
to
on control panel to
ICE
WATER FILTER
MAKER
CIRCUIT CLEANING
E
W
E
W
E
W
W
E
W
E
W
E
13
EN
Publicité
