Smeg RBMU36R Guide D'installation page 15

3. PREPARING THE INSTALLATION
TOP COMPRESSORS UNIT:
Electrical connection
Water connection
fig.2 Back of appliance
Operate as follows:
> Unwind the electric cable and connect it directly
to the wall socket.
> Make sure the appliance is in the Stand-by
condition and that all ights are off; should it be
not so press the Unit button to switch it off.
1
fig.3 Front of appliance
> Firmly tighten with fingers - a tool / wrench
should not be needed to make a proper seal.
Turn on the water and ensure all connections
are not leaking prior to pushing the unit into the
opening.
3.4. Leveling
Adjust the appliance level by means of the
front levelling feet and the rear adjustable
wheels.
2
1
Operate as follows:
> If necessary, remove the bottom plinth or
grille (it is kept in position by magnets), adjust
the height of the levelling feet [ 1 ] by means of
a 17 mm (11/16") wrench.
>
Then adjust the height of the rear wheels by
turning the front adjusting bolts [ 2 ] clockwise
(raise) or counter-clockwise as it may be
required.
Take care if using a power driver for this and
lower the clutch to prevent damaging the
leveling mechanism.
> Remount the bottom plinth or grille.
www.smeg.com
2
1
15
EN