SilverCrest SSWR B1 Instructions D'utilisation Et Consignes De Sécurité page 37

Troubleshooting
The robot vacuum cleaner frequently indicates
errors with a short beep:
No. Tone
01 ·
02 ··
03 ···
Note: If the suggested solutions do not solve the
problem, proceed as follows:
Reset the robot vacuum cleaner by switching it off
and back on again using the power switch
Fault
The robot vacuum cleaner keeps
crashing into objects.
The run time of the robot vacuum
cleaner is too short.
The "Start / Pause" button
does not light up whilst charging.
The suction power of the robot
vacuum cleaner has decreased.
The dust collector is spilling dirt. The dust collector
19
Cause
The wheels
are not working.
30
The anti-drop sensors
the bumper
The robot vacuum cleaner has
stopped moving.
.
5
Possible cause
The bumper
4
cannot spring back.
The battery is not fully charged.
- The mains cable
2
adapter is not properly connected.
- A foreign object e.g. animal
hair is blocking the charging
contact on the charging
10
dock .
9
The high performance filter
dirty or moist.
Solution
or side brushes Check the wheels
32
brushes
Clean the anti-drop sensors
and
31
31
are not working.
4
to remove any foreign objects.
Carry the robot vacuum
cleaner to a different location
and restart it.
If the robot vacuum cleaner still does not work
after this reset, please contact the service centre.
Solution
is pushed in and Tap the bumper
to release any dirt under the
bumper
bumper
Recharge the robot vacuum
cleaner.
- Check that the mains adapter is
with mains
11
suitable for this robot vacuum
cleaner.
- Clean the charging contact
on the charging station
Clean the high performance filter
is
27
27
is too full. Empty the dust collector
19
or side
32
.
30
and shake the bumper
10-20 times
4
, or loosen the
4
.
4
9
or replace it with a new one.
.
19
GB/IE
4
10
.
37