SilverCrest SSWR B1 Instructions D'utilisation Et Consignes De Sécurité page 35

Place the microfibre cloth
The six hook-and-loop fasteners
the microfibre cloth
Fig. C).
Flip up the cover
7
Remove the dust collector
carrying handle
25
Fill the water tank
20
port . Please note the markings denoting the
24
maximum filling level (300 ml).
Then put the water tank
vacuum cleaner and close the cover
Press the "Start / Pause" button on the robot
vacuum cleaner
2
to start mopping.
Note: The device will not vacuum when mopping.
Press the "Start / Pause" button again on the robot
vacuum cleaner
2
finish mopping.
When finished, flip open the cover
Remove the water tank
carrying handle
23
water.
Now put the dust collector
robot vacuum cleaner and close the cover
Note: the different vacuum modes can also be
used for the mop function.
Setting a vacuuming schedule
You can set a schedule so that the robot vacuum
cleaner will clean automatically.
Note: Be aware that all pre-set times will be erased
if the robot vacuum cleaner is switched off (power
switch in position "O").
5
Note: Beep tones will sound if the time and schedule
have been successfully set. If this does not happen,
the settings were not saved.
Setting the time:
Make sure that the robot vacuum cleaner is
switched on and point the remote control at it.
Press the button
keys to set the time.
37
over the frame
13
ensure that
35
remains in place (see
13
to open it (see Fig. B).
by pulling on the
19
.
using the water filling
back in the robot
20
.
7
or the remote control
38
or the remote control
38
.
7
by pulling on the
20
. Empty out any remaining
back in the
19
and use the direction
44
. Press the
14
To delete the time entry, set the clock to "00:00".
Setting the schedule:
Note: The robot vacuum cleaner will always start
vacuuming at the scheduled time, unless it is switched
off.
Make sure that the robot vacuum cleaner is
switched on and point the remote control at it.
Press the
keys
to set the time.
37
Press the
To delete the time entry, set the clock to "00:00".
Cleaning and storage
to
Set the power switch
cleaning the product.
Unplug the mains cable
socket before cleaning the product.
Do not rinse the product directly with water.
Do not wipe the product with a cloth soaked in
. water.
7
Disconnect the power supply if the product will
not be used for an extended period.
Part
Dust collector
19
Primary filter
26
high performance
filter
27
Side brushes
30
Anti-drop sensors
Front wheel
34
Cleaning the dust collector and filter
Clean the dust collector
dust and then rinsing with water. You can like-
wise tap the dirt out of the primary filter
clean it with water. Please dry the dust collec-
tor and the primary filter
19
re-installing them in the product. Please tap the
dirt out of the high performance filter
button again to save the entry.
44
button and use the
39
button again to save the entry.
39
to position "O" before
5
from the mains
11
Cleaning intervals
Depends on usage
Weekly, 2 x weekly
,
if very dirty
Every 4 weeks
Every 2 weeks
31
Every 4 weeks
by tapping out the
19
fully before
26
direction
and
26
and
27
GB/IE 35