SilverCrest SSWR B1 Instructions D'utilisation Et Consignes De Sécurité page 36

clean with the included cleaning brush. Please
do not clean this filter with water.
Proceed as shown in the following illustrations.
Cleaning the side brushes
Clean the side brushes
hair or dirt.
Replace defective side brushes
described in the chapter "Attaching the side
brushes".
36 GB/IE
by removing any
30
. Proceed as
30
Cleaning the main housing
Clean the front wheel
hair. If necessary, remove the front wheel
by pulling it out.
Clean the anti-drop sensors
their sensitivity.
Clean the anti-collision sensor
its sensitivity.
Cleaning the charging dock
Clean the charging contacts
ing dock
and the underside of the robot
9
vacuum cleaner with a dry cloth.
Cleaning the water tank
After mopping, remove the water tank
pulling on the carrying handle
out any remaining water.
Remove both the frame
cloth from the underside of the robot vacuum
13
cleaner by pulling the frame
Remove the microfibre cloth
and allow it to dry.
Wipe the water tank
and allow it to dry.
Rinse the frame
14
Cleaning the microfibre cloth
Wash the cloth in the washing machine at 40 °C.
Please do not use fabric softener.
Please do not use bleach.
Please do not dry in the tumble dryer.
Please do not iron.
Please do not dry clean.
to remove any tangled
34
34
to maintain
31
to maintain
4a
on the charg-
10
by
20
and empty
23
and the microfibre
14
off.
14
from the frame
13
with a dry, soft cloth
20
under running water.
14