SilverCrest SSWR B1 Instructions D'utilisation Et Consignes De Sécurité page 31

CAUTION! Keep the charging dock
direct sunlight.
CAUTION! Change the position of the charging
dock as seldom as possible.
9
Attaching the side brushes
Note: When attaching the side brushes
sure that the markings "L" and "R" on the bottom of
the robot vacuum cleaner and on the side brushes
match.
Install the side brushes
screws counter-clockwise with a cross-tip screw-
driver.
Install the side brushes
opening, and tighten the screws clockwise.
Verify the side brushes
Inserting the batteries
(remote control) (Fig. D)
Remove the battery compartment cover
the back of the remote control
downwards in the direction of the arrow.
Insert two type AAA batteries (not included)
into the battery compartment
Operation
out of
9
, make
30
30
by unscrewing the
30
in the designated
30
are secure.
30
on
48
by sliding it
16
or replace the
47
old batteries with new ones. Only use batteries
of the specified type (see "Technical data").
Ensure correct polarity. This is indicated in the
battery compartment
Close the battery compartment
the battery cover in the opposite direction of
the arrow.
The display will light up and the time indi-
36
cator and schedule indicator
45
in the display .
36
Note: Remove the batteries from the remote
control
if it will not be used for an extended
16
period.
Switching the product on / off
Press the power switch
product. "I" indicates switched on, "O" indicates
switched off. If the "Start / Pause" button
lights up green, the product was successfully
switched on.
Note: Do not switch off the product after it has fin-
ished cleaning. Leave it in the charging dock
that it is ready for the next cleaning session.
Note: Pressing the power switch
time setting and vacuuming schedule.
.
47
by replacing
47
will appear
46
on the side of the
5
2
so
9
will erase the
5
GB/IE 31