Publicité
Les langues disponibles
Les langues disponibles
6.A SETTING UP THE STEREO HUB
1.
3.
4.
1.Place the batteries in your remote control
using the supplied key.
Ensure that the polarity is correct.
2.Screw the antenna on the Stereo Hub.
3.Select the right plug for your AC outlet.
4.Then Connect the power cable between your
Stereo Hub and your AC outlet.
2.
SERVICE
5.
5.The Stereo Hub begins its startup sequence.
Please wait until it is finished. This is how it works: the
WiSA LED remains switched off for 50 seconds, then
flashes for 20 seconds before switching off again.
The end of the startup sequence is confirmed once
the WiSA LED switches off.
6.The WiSA LED on the Stereo Hub should flash
each time you press the remote control. Run a test
to check pairing.
WISA
PAIRING
11
EN
Publicité
