Publicité
Les langues disponibles
Les langues disponibles
11.B CONNECTION VIA WiSA SOURCE
Some sources, like TVs/streamers/consoles, have WiSA compatibility.
This means you do not need the Stereo Hub and can connect your source directly to your speakers.
To do this:
Connect your speakers using the supplied power cables.
Î
The STATUS LED on the rear of your speakers lights up:
Î
1 orange flash
Î
then turns puis devient blue
Î
and finally turns off indicating the end of the process (wait 1mn before the LED goes out). Press the
Î
"PAIR" button on each speaker for 3-4 seconds, then wait for the LEDs to start flashing orange rapidly.
Press once the "PAIRING" button on the source.
Î
Pairing is confirmed once the LEDs on both speakers are lit continuously..
Î
By default, your speakers are set as Left channels. To revert to stereo, see
Î
Your source needs to have built-in volume
management so you can control it.
DROITE
RIGHT
USER MANUAL
p.13.
65
EN
Publicité
