Télécharger Imprimer la page

Peavey ValveKing 50 Manuel D'utilisation page 25

Publicité

Rear Panel
22
23
(22) VOLTAGE SELECTOR SWITCH
This selects between two different AC line/mains voltages. This should not normally need to be adjusted by
the user, hence why it is covered with a clear plastic shield. This should already be set to the correct line/
mains voltage in your country/territory.
(23) AC POWER INLET:
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this
connector to provide power to the unit. Damage to the equipment may result if improper line voltage is used.
(See VOLTAGE SELECTOR SWITCH #22).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not
have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded
properly. To prevent the risk of shock or fire hazard, always make sure that the amplifier and all associated
equipment is properly grounded.
NOTE: FOR UK ONLY
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows: (1) The wire which is coloured green and
yellow must be connected to the terminal which is marked by the letter E, or by the Earth symbol, or coloured
green or green and yellow. (2) The wire which is coloured blue must be connected to the terminal which is
marked with the letter N, or the colour black. (3) The wire which is coloured brown must be connected to the
terminal which is marked with the letter L, or the colour red.
To avoid the risk of electrical shock, do not place fingers or any other objects into empty tube sockets while
power is being supplied to unit.
(24) FUSE
The fuse is located within the cap of the fuse holder. If the fuse should fail, IT MUST BE REPLACED WITH THE
SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE
WARRANTY. If the amp repeatedly blows fuses, it should be taken to a factory authorized center for repair.
WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED
FROM ITS POWER SOURCE.
24
22
24
23
25
22
24
23
25
25
26
27
28
26
27
28
30
31
26
27
28
30
31
22
23
24 25 27
30
31
32
33
34
32
33
34
35
32
33
34
35
28
30
31 32
26
29
33
35
35
34

Publicité

loading

Ce manuel est également adapté pour:

Valveking 100Valveking serieValveking 20Valveking 20mh