Publicité

Liens rapides

6505+
112 Combo
®
Guitar Amplifier
Operating
Manual
www.peavey.com

Publicité

Table des Matières
loading

Sommaire des Matières pour Peavey 6505+ 112 Combo

  • Page 1 6505+ 112 Combo ® Guitar Amplifier Operating Manual www.peavey.com...
  • Page 2 ATTENTION: Afin de réduire le risque de choc électrique, ne pas enlever le couvercle. Il ne se trouve à l’intérieur aucune pièce pouvant être reparée par l’utilisateur. Confiez I’entretien et la réparation de l’appareil à un réparateur Peavey agréé. AVIS: Dans le but de reduire les risques d’incendie ou de decharge electrique, cet appareil ne doit pas etre expose a la pluie ou a l’humidite et aucun objet rempli de liquide, tel qu’un vase, ne doit...
  • Page 3: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electrical products, basic cautions should always be followed, including the following: Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any of the ventilation openings.
  • Page 4: Wichtige Sicherheitshinweise

    WICHTIGE SICHERHEITSHINWEISE ACHTUNG: Beim Einsatz von Elektrogeräten müssen u.a. grundlegende Vorsichtsmaßnahmen befolgt werden: Lesen Sie sich diese Anweisungen durch. Bewahren Sie diese Anweisungen auf. Beachten Sie alle Warnungen. Befolgen Sie alle Anweisungen. Setzen Sie dieses Gerät nicht in der Nähe von Wasser ein. Reinigen Sie es nur mit einem trockenen Tuch.
  • Page 5: Instructions Importantes De Securite

    INSTRUCTIONS IMPORTANTES DE SECURITE ATTENTION: L’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: Lire ces instructions. Gardez ce manuel pour de futures références. Prétez attention aux messages de précautions de ce manuel. Suivez ces instructions. N’utilisez pas cette unité proche de plans d’eau. N’utilisez qu’un tissu sec pour le nettoyage de votre unité.
  • Page 6 INSTRUCCIONES IMPORTANTES PARA SU SEGURIDAD CUIDADO: Cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: Lea estas instrucciones. Guarde estas instrucciones. Haga caso de todos los consejos. Siga todas las instrucciones. No usar este aparato cerca del agua. Limpiar solamente con una tela seca.
  • Page 7 1x12 combo-amp configuration. The new 6505 Plus 112 combo harnesses the full gain and legendary tone of the Peavey 6505 Series, which since 1991 has defined the sounds of extreme rock guitar, into a format that is equally suited to clubs, rehearsal rooms and studios.
  • Page 8 Front Panel POWER SWITCH This two-way toggle switch applies mains power to the unit. STANDBY SWITCH This two-way toggle switch allows the amp to be placed in the STANDBY mode. In the STANDBY position the tubes stay hot but the amplifier is not operational. Switching to the ON position places the amp in active mode.
  • Page 9 Front Panel RHYTHM CHANNEL POST CONTROL This control adjusts the volume of the Rhythm channel. HIGH CONTROL This passive control regulates the high frequencies for the Rhythm channel. MID CONTROL This passive control regulates the mid frequencies for the Rhythm channel. LOW CONTROL This passive control regulates the low frequencies for the Rhythm channel.
  • Page 10 MSDI ™ Microphone Simulated Direct Interface. Peavey's exclusive MSDI simulates teh sound of a microphone about 8" from teh cone, allowing the user to send a clean signal to the mixing console. This is a non powered output and safe for use with any mixing console.
  • Page 11: Footswitch

    FOOTSWITCH CHANNEL SWITCH Selects between the Rhythm and Lead channels. EFFECTS SWITCH Activates the Rhythm channel crunch boost.
  • Page 12: Power Consumption

    Crunch Boost (Clean channel only): Special two-button unit with LED indicators (not included, Increased gain and altered reponse for very brown voicing. Peavey #00592720) for channel selection (Channel) and remote activation of the Crunch boost (BOOST). Equalization (both channels) Custom Low, Mid & High EQ.
  • Page 13 Logo referenced in Directive 2002/96/EC Annex IV (OJ(L)37/38,13.02.03 and defined in EN 50419: 2005 The bar is the symbol for marking of new waste and is applied only to equipment manufactured after 13 August 2005...
  • Page 16 Features and specifications subject to change without notice. Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian, MS 39305 (601) 483-5365 • FAX (601) 486-1278 • www.peavey.com © 2009 00000000 Printed in the U.S.A.

Table des Matières