Changing The Parameters; Access To Parameter Changing; Menu Mask Table - Mitsubishi Electric s-MEXT 006-044 Manuel D'utilisation

UM_s-MEXT_ME18relC_00_11_18_ML
2.6

CHANGING THE PARAMETERS

2.6.1

Access to parameter changing

The settable parameters can be distinguished according to the modification access mode, into three groups:

Parameters that can be reached using the "User" menu with the "User" password.
2.6.2

Menu mask table

To access the main menu, showing the available submenus, click [HOME].
Press [UP] or [DOWN] to move from one mask to another inside the same menu.
Press [ENTER] to access the parameter, press [UP] or [DOWN] to change the value of the parameter.
Below are the masks of the menus used to set the parameters. As well as the information displayed on every single mask, the unit setting parameters
(Par N. column) are also included.
Mask of the terminal
Scheduler

--------------- P32.01
Scheduler config:
N
Info

Insert a NEW
USER
password
0000
Evolution
Cod. ME 18.01 EN Œ
Man.
HW pCO5+M NAND 50MB
Flash 2MB + 7MB + 4MB
Ram 2048KB
Boot 05.01 Bios06.21
Setpoint

Active set point
Set point cooling:
24.0 °C
Set point heating:
00.0 °C
USER MANUAL
Description of the mask
Access mask to clock menu. Press "Up" or "Down" to scroll the other masks and "Esc" to return to the submenu.
Submenu allowing the activation of time band management.

Parameter to set the time bands (N:disabled - Y:enabled)
Access mask to Info menu. Press "Up" or "Down" to scroll the other masks and "Esc" to return to the submenu.
Submenu allowing to change user passwords and display software info.

Sets a new password.
Warning: the value set in this field is the one and only to access the user menu.
This mask contains the reference information of the software [Code ME 18.01 EN],
The closed padlock symbol shows that the board is provided with its propriety software.
The second part of the mask shows information about the hardware: size (M, L, XL), memories (NAND 32MB,
flash 2+7MB, ram 2048KB) and versions of the installed operating system (boot and bios).
Access mask to Setpoint menu. Press "Up" or "Down" to scroll the other masks and "Esc" to return to the
submenu.

Active set point display mask
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
41