Password Management - Mitsubishi Electric s-MEXT 006-044 Manuel D'utilisation

UM_s-MEXT_ME18relC_00_11_18_ML
The access to the "User", "Service" and "Factory" menus requires a password. The following chapter explains how to manage the passwords.
2.2.2

Password management

There are three levels that may be accessed upon entering a numeric password. There are 3 clearance levels:

"User" password, for the user.
To enter the password, type every single digit in the set order from left to right.
To move from one digit to the next, just press the [ENTER]
To move from one digit to the previous, just press the [ESC]
window.
The following table reports the password value:
Once at the last digit of the password, by pressing the [ENTER] key the software will compare the entered password with those stored in its memory. If
the entered password should not be correct, the message "Wrong Password !!!" will appear for a few instants, all digits will be reset, and the cursor will
move back to the first digit, on the left end of the password space.
To go back with the cursor to the previous password digit, just press the [ESC] key.
By pressing the [ESC] key with the cursor on the first digit on the left, the system goes back by one level.
To change the "User" password access the "Info" menu inside the "User" menu and scroll the masks until the "User" password change mask
appears:
USER MANUAL
Esc
Esc
Esc
Esc
Esc
Figure 2-3: Tree for moving around the "User menu"
key.
key. If the cursor should be on the first digit to the left, then this brings back to the main
USER PASSWORD
1234
(modifiable)
Insert a NEW
USER
password
User Menu

Serial Menu
Selection

Alarm Out Menu
Selection

Scheduler Menu
Selection

Info Menu
Selection

Alarm Out 2 Menu
Selection

0000
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
31
Esc / 
Serial Menu
Esc /  Alarm Out Menu
Esc / 
Scheduler Menu
Esc /  Info Menu
Esc /  Alarm Out 2 Menu