Behringer XENYX X1204USB Manuel D'utilisation page 18

18
XENYX X1204USB/1204USB User Manual
3. Digital E ects Processor
Fig. 3.1: Digital e ects module (only X1204USB)
24-BIT MULTI-EFFECTS PROCESSOR
Here you can nd a list of all presets stored in the multi-e ects processor.
This built-in e ects module produces high-grade standard e ects such as
reverb, chorus, anger, delay and various combination e ects. The integrated
e ects module has the advantage of requiring no wiring. This way, the danger
of creating ground loops or uneven signal levels is eliminated at the outset,
completely simplifying the handling.
These e ect presets are designed to be added to dry signals. If you move the
FX TO MAIN control, you mix the channel signal (dry) and the e ect signal.
This also goes for mixing e ects signals with the monitor mix. The main
di erence is that the mix ratio is adjusted using the FX TO MON control. Of course,
a signal has to be fed into the e ects processor via the FX control in the channel
strip for both applications.
◊ ◊
On the following page, you will find an illustration showing how to
connect your foot switch correctly.
LEVEL
The LED level meter on the e ects module should display a su ciently high
level. Take care to ensure that the clip LED only lights up at peak levels. If it is
lit constantly, you are overloading the e ects processor and this could cause
unpleasant distortion. The FX control (AUX SEND 2) determines the level that
reaches the e ects module.
PROGRAM
You can select the e ect preset by turning the PROGRAM control. The display
ashes the number of the current preset. To recall the selected preset, press the
button; the ashing stops. You can also recall the selected preset with the
foot switch.
4. Installation
4.1 Cable connections
You will need a large number of cables for the various connections to and from
the console. The illustrations below show the wiring of these cables. Be sure to
use only high-grade cables.
¼" TS footswitch connector
strain relief clamp
sleeve
tip
sleeve
pole 1/ground
tip
pole 2
The footswitch connects both poles momentarily
Fig. 4.1: ¼" TS connector for foot switch