Publicité
Les langues disponibles
Les langues disponibles
GARI EN TRACTOR SERVICE GUIDE
PROBLEM
10. Excessive front tire wear.
11. Hydraulic lift operates erratically.
POSSIBLE CAUSE
Bent or damaged spindles, tie rod
or drag link.
Linkage out of adjustment.
CORRECTION
Replace damaged parts. See your
m
Ariens Dealer.
Adjust linkage. See ''ADJUSTMENTS-
MAINTENANCE" section of this
manual.
Transmission oil cold.
Allow transmission to warm up
before applying load.
12. Rear rock shaft will not raise or
Selector Knob not in proper position.
Place Selector Knob in front
14. Tractor will not move with engine
running.
15. Tractor creeps. with Hydrostatic
Control Lever in neutral.
-
Free-wheeling valve open.
Transmission oil level low.
Park-lock cable out of adjustment.
Park-lock pin sticking.
Park-lock cable failed.
Hydrostatic control linkage out of
adjustment.
No hydraulic pressure or flow in
system.
Close free-wheeling valve. See
""OPERATION"" section
of this manual.
Add transmission oil to proper
level. See '"LUBRICATION"'
Section of this manual.
Adjust according to ''ADJUST-
MENTS-MAINTENANCE"' section
of this manual.
É
See your Ariens Dealer.
See your Ariens Dealer.
Adjust hydrostatic control linkage.
See your Ariens Dealer.
^
Check system and see your
Ariens Dealer.
Hydrostatic control linkage out of
adjustment.
Adjust hydrostatic control linkage.
See your Ariens Dealer.'
16. Hydrostatic control linkage will not
Stay in-adjustment.. -
Improper operation — attempting to
move Hydrostatic Control Lever with
Neutralizer Pedal depressed.
Transmission oil level low.
Excessive load.
"Hardware по! propérly tightened or
overtorqued and stripped.
- 47. Hard to lift hood.
- Lack of lubrication.
Use Neutralizer Pedal for —
emergency stops only. Keep foot
off pedal in normal operation.
Add transmission oil to proper
level. See ''CUBRICATION""
section of this manual.
|
Do not operate under extreme
load to avoid damage to system.
Tighten or replace fiardware.
|
| .20-
Grease hood ойр and bolt.
Publicité
