Publicité
Les langues disponibles
Les langues disponibles
HYDROSTATIC CONTROL ADJUSTMENT
CONTROL LEVER FRICTION ADJUSTMENT
If the tractor has a tendency to slow down or speed up without
touching the Hydrostatic Control Lever, it will be necessary to in-
crease the spring pressure on the friction plates by tightening
the screws at "А" and "В", Figure 18. Friction plates must re-
main parallel. Check parallelism and adjust screws equally. Ac-
cess to thesé screws can be gained by raising the rear deck of
' the tractor and inserting a screw driver through the access holes
as shown.
. If the tractor has a tendency to speed up, tighten screw "А"
slightly more than screw "В".
If the tractor has a tendency to slow down, tighten screw "В"
pions more than screw "А".
HYDROSTATIC CONTROL LEVER
FRICTION PLATES
, CONTROL CONSOLE -
REMOVED
FOR CLARITY
HYDROSTATIC
CONTROL
" DRIVER
FIGURE 18
PARK LOCK MAINTENANCE AND ADJUSTMENT
-13-
OVER CENTER
PIVOT PLATE
PARK LOCK PIN
A(ENGAGED)
FIGURE 19
OVERCENTER LATCH
"АСТУАТЕ5
PARK LOCK ENGAGES
FIGURE 20
Publicité
