Hilti VC 20H-X Manuel D'utilisation page 35

7. Switch on the power tool.
The vacuum cleaner will continue to run for a short time after the electric tool is switched off in
order to ensure that all dust is removed from the suction hose.
7.4 Picking up dry dust
Before picking up dry dust, especially dust from mineral materials, always check to ensure that the
correct dust bag is fitted in the container. The material picked up by the vacuum cleaner can then be
disposed of cleanly and easily.
CAUTION
Risk of injury by dusts that are hazardous to health! Hazardous material that has been vacuumed up can
escape if a filter element is not used.
▶ Use the vacuum cleaner only with a filter element installed.
▶ Check that the filter element is dry and that the correct type of dust bag is fitted.
7.5 Vacuuming up liquids
CAUTION
Risk of injury by dusts that are hazardous to health! Hazardous material that has been vacuumed up can
escape if a filter element is not used.
▶ Use the vacuum cleaner only with a filter element installed.
1. Check the container level monitoring system. → page 31
2. If possible, use a separate filter element for wet applications.
For information about suitable filters, consult the instructions for use for accessories → page 25.
3. After vacuuming up liquids, open the two catches.
4. Lift the suction head off the waste material container and place it on a level surface so that the filter
element can dry.
5. Empty the waste material container and use a water hose to rinse it out. Use a brush to clean the
electrodes and clean the filter element, after allowing it to dry, by wiping it off with your hand.
6. Allow the waste material container to dry.
7.6 After use of the vacuum cleaner
1. Switch off the electric tool.
2. Turn the vacuum cleaner control switch to the "OFF" position.
3. Unplug the vacuum cleaner's supply cord from the power outlet.
4. Coil up the supply cord and hang it on the hook.
5. Empty the container and clean the appliance by wiping it with a damp cloth.
6. Coil up the suction hose.
7. Store the vacuum cleaner in a secure, dry place where it is inaccessible to unauthorized users.
7.7 Emptying dry dust from the waste material container
1. Disconnect the supply cord plug from the power outlet.
2. Open the 2 catches.
3. Lift the suction head off the waste material container and place it on a level surface.
4. Empty the waste material container:
▶ H-class vacuum cleaners: Remove the dust bag from the waste material container and insert a new
dust bag.
Always use a dust bag when working with the H-class vacuum cleaner.
5. Then fit the suction head on to the waste material container and close the 2 catches.
*2326117*
2326117 English 29