Güde GNS 250 VS Traduction Du Mode D'emploi D'origine page 23

Troubleshooting
Issue
Not working when pressing the
on-off switch.
Grinding discs do not turn when
tool is switched on.
Device is not running at full speed
or unusual sounds from motor.
Possible causes
No electricity
On-off switch defective
Wear on the rubber drive wheels. Increase the contact pressure
Motor is overheating
Motor defective
Recommended solution
Check the electricity supply
Have on-off switch replaced by
an approved after-sales service
team.
using the setscrew until the
grinding discs start turning
again.
Turn off device and leave to cool
for 30 minutes.
Contact an approved after-sales
service provider.
ENGLISH
19