Publicité
Les langues disponibles
Les langues disponibles
English
Technical Data
Wet grinder
Art. No
Rated voltage
Rated frequency
Rated input
Rated idle speed
Degree of protection
Wet grinding disc ø
Wet grinding disc Width max.
Wet grinding disc Hole diameter L
Wet grinding discGrain size
Max. wear until wet grinding disc replacement ø
Dry grinding disc ø
Dry grinding disc Width
Dry grinding disc Hole diameter
Weight
Read and understand the operating
instructions before using the
appliance. Familiarise with the
control elements and how to use the appliance
properly. Abide by all the safety measures stated in
the service manual. Act responsibly toward third
parties.
The operator is responsible for accidents or risks to
third parties.
Persons over 16 years of age can only work on the
appliance. An exception includes youngsters trained
in order to reach knowledge under supervision of
the trainer during occupational education.
In case of any doubts about connection and opera-
tion refer please to our customer center
Specified Conditions Of Use
This device may only be used for grinding e.g. axes,
scissors, blades, notching tools of various lengths
and blade widths as well as textures, notching
tools of any shape, spades, planers made of tool
steel above 60 HRC, taking safety regulations into
account.
The machine may only be used in a technically
perfect condition and taking into account all safety
information.
Do not use this product in any other way as stated
for normal use. Not observing general regulations
in force and instructions from this manual does not
make the manufacturer liable for damages.
It is strictly prohibited to disassemble,
modify and purposely remove the protective
equipment on the unit and fit other protective
equipment instead.
Residual risks
Even when the device is used properly and all safety
regulations are complied with, there still may be
some residual risks.
· Never put your hand in the grinding disc area.
· Risk of injury for fingers and hands if the tool to
be ground is guided or supported incorrectly.
· Tool parts flying off
· noise emissions
· dust emissions
· vibrations to hand and arms
· Danger of burns
Tool and workpiece heat up during operation.
· Risk of injury
Sharp tools and workpiece edges
Emergency procedure
Conduct a first-aid procedure adequate to the
ENGLISH
15
GNS 250 VS Set
55227
230 V
50 Hz
150 W
30 - 150 min
-1
IP 20
250 mm
40 mm
12 mm
220 K
150 mm
200 mm
30 mm
12,5 mm
13 kg
Publicité
