Balluff FT 50 RLA Serie Instructions De Service Et De Montage page 49

Mounting and
operating instructions
Keys In operating mode
Activate set-up mode:
Simultaneously pressing these keys
(> 3 s) activates the set-up mode.
After this period, the power supply
indicator BA flashes
Entire control
 set FT 50 RLA, see illustr. 11.
panel
The LEDs show the status of function
no.1.
SET
When all the LEDs start flashing imme-
diately
 unlock FT 50 RLA, see
„Unlocking keys" (below).
SET
No function
SET
Activate factory setting during
Power ON:
Keep
until the LEDs stop flashing and light up
permanently. The operating indicator BA
lights up green.
Once the
sensor is reset. The FT 50 RLA is now in
its initial state.
No function
Continue
Unlock keys during Power ON:
Keep
until the LEDs stop flashing and light up
permanently. The status indicator ZA
lights up red.
The control panel is unlocked once the
INFORMATION
A time lock prevents short unintentional pressure on the keys from activating configuration
mode.
FT 50 RLA Disctance sensor - GB - 068-13671 - 19.05.2016-12
SET
key pressed (approx. 10 s),
SET
key is released, the
key pressed (approx. 10 s),
key is released.
General operating functions
In configuration mode
Quit set-up mode:
First press the
key.
All settings are then stored.
SET
Once the
RUN mode.
The operating indicator BA lights up permanently
again.
INFORMATION
Should the power supply fail during the
setting procedure, all settings are lost.
A brief pressing of the
status of respective function or activates storage
and confirmation of the set values.
The function status is indicated by the status
indicator ZA
(LED ON = active, LED OFF = not active).
Press the
the function table.
The function number is indicated by a clear LED
pattern.
The first function follows the last available
function.
key and then also the
key is released, the sensor is in
SET
key changes the
key to select the next function in
SET
49