Publicité
Les langues disponibles
Les langues disponibles
4. Cut the middle of the outer protective plastic bag to remove the mounting
plate.
5. Remove the screws from each end of the mounting plate. This plate will be
used as the rear wall template and for mounting. Reinstall the screws into
the holes where they were removed.
B. Finding the wall studs
1. Find the studs, using one of the following methods:
A. Stud finder – a magnetic device which locates nails.
B. Use a hammer to tap lightly across the mounting surface to find a solid
sound. This will indicate a stud location.
2. After locating the stud(s), find the center by probing the wall with a small nail
to find the edges of the stud. Then place a mark halfway between the
edges. The center of any adjacent studs should be 16"(40.6 cm) or 24"(61
cm) from this mark.
3. Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO AT LEAST ONE WALL STUD.
1 (844) 538-7890
support@gaslandchef.com
Screws
Mounting Plate
Wall
Studs
Center
www.gaslandchef.com
8350 Patriot Blvd STE B, N. Charleston, SC 29418
Screws
07
Publicité
