Publicité
Les langues disponibles
Les langues disponibles
8. Place the blower unit back into the opening.
AFTER:Fan Blade Openings Facing Back
End B
CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are
not pinched, and that they are properly secured.
NOTE: The blower unit exhaust openings should match exhaust openings on rear
of microwave oven.
9. Secure the blower unit to the microwave with the original screw.
10. Replace the blower plate in the same position as before with the screw. Make
sure the screw is tight.
11. Attach the exhaust adaptor to the rear of the oven by sliding it into the guides
at the top center of the back of the oven.
Push in securely until it is in the lower locking tabs. Take care to assure that the
damper hinge is installed so that it is at the top and that the damper swings freely.
1 (844) 538-7890
support@gaslandchef.com
Blower Plate
Adaptor
Guide
End A
Back of
Microwave
Blower Motor
Screw
Back of
Microwave
Guide
Locking Tabs
www.gaslandchef.com
8350 Patriot Blvd STE B, N. Charleston, SC 29418
27
Publicité
