GASLAND OTR1902 Instructions D'installation page 11

D. Aligning the wall plate
CAUTION: Wear gloves to avoid cutting fingers on sharp edges.
1. Draw a vertical line on the wall at the center of the 30" wide space.
2. Draw a horizontal line on the wall at the bottom of "Rear Wall Template".
3. Find a wall stud in area "E" of mounting plateRefer to section 1B. Finding the
wall studs.
4. For attaching the mounting plate into stud drill a 3/16" hole into wood stud.
Drill a 5/8" hole fortoggle bolt in 1 other location ( Hole A or Hole B).
NOTE: DO NOT MOUNT THE PLATE AT THISTIME.
NOTE: Holes A and B are inside area E. If neither of Holes A and B are not in a
stud, find a stud somewherein area E and draw a circle to line up with the stud. It
isimportant to have at least one wood screw mounted firmly in a stud to support
the weight of the microwave. Set the mounting plate aside.
1 (844) 538-7890
support@gaslandchef.com
Centerline
notches
Hole B
Hole B
Area E
Draw a Vertical Line
on Wall from Center
of Top Cabinet
Hole A Horizontal Line
Draw a horizontal line on wall at the
bottom of "Rear Wall Template".
www.gaslandchef.com
8350 Patriot Blvd STE B, N. Charleston, SC 29418
09