Publicité
Les langues disponibles
Les langues disponibles
External Exhaust Ducting
Outside top exhaust (example only)
The following chart describes an example of one possible ductwork installation.
Equivalent lengths of duct pieces are based
on actual tests and reflect requirements for
good venting performance with any vent hood.
* IMPORTANT: If a rectangular-to-round transition adaptor is used, the bottom
corners of the damper will have to be cut to fit, using the tin snips, in order to
allow free movement of the damper.
Outside back exhaust (example only)
The following chart describes an example of one possible ductwork installation.
Equivalent lengths of duct pieces are based
on actual tests and reflect requirements for
good venting performance with any vent hood.
NOTE: For back exhaust, care should be taken to align exhaust with space
between studs, or wall should be prepared at the time it is constructed by leaving
enough space between the wall studs to accommodate exhaust.
1 (844) 538-7890
support@gaslandchef.com
Duct Pieces
Roof Cap
12 Ft. (3.6 m) Straight Duc
(6"/15.2 cm Round)
Rectangular-to-round
Transition Adaptor*
Duct Pieces
Wall Cap
3Ft. Straight Duc
(3 1/4" x 10"/8.2 x 25.4 cm
Rectangular)
90° Elbow
www.gaslandchef.com
8350 Patriot Blvd STE B, N. Charleston, SC 29418
Equivalent
Number
x
Length
Used
24 Ft. (7.3 m)x (1) =
12 Ft. (0.3 m) x (1) =
5 Ft. (1.5 m) x (1) =
Total Length =
Equivalent
Number
x
Length
Used
40 Ft. (12.2 m) x (1) =
3 Ft. (0.9 m) x (1) =
10 Ft. (3 m x (2) =
Total Length =
Equivalent
=
Length
24 Ft. (7.3 m)
12 Ft. (3.6 m)
5 Ft. (1.5 m)
41 Ft. (12.5 m)
Equivalent
=
Length
40 Ft. (12.2 m)
3 Ft. (0.9 m)
20 Ft. (3 m)
63 Ft. (19.2 m)
13
Publicité
