GASLAND OTR1902 Instructions D'installation page 17

A1. Attach the mounting plate to the wall
Attach the plate to the wall using toggle bolts. At least one wood screw must be
used to attach the plate to a wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the holes designated to go into
drywall and reattach the toggle wings to 3/4" (19 mm) onto each bolt.
To use toggle bolts:
Mounting
Plate
3. Place the mounting plate against the wall and insert the toggle wings into the
holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screw, make sure the bottom of
the mounting plate touch the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers between the back of the
mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall to help tighten the bolts.
1 (844) 538-7890
support@gaslandchef.com
Thickness
Toggle Wings
Toggle
Bolt
Wall
Bolt End
www.gaslandchef.com
8350 Patriot Blvd STE B, N. Charleston, SC 29418
15