afx light DYNAMIC-LZR Manuel D'utilisation page 5

1. Press the MENU button until "SHND" is displayed, press ENTER.
2. The Display will show either "SOUN" or "AUTO1-AUTO9". Press the UP or DOWN buttons until the desired setting
is displayed. Press ENTER to confirm.
SOUD – Sound active mode
1. Press the MENU button until "SOUD" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to activate sound active
mode, or "OFF" to deactivate sound active mode.
3. Press ENTER, then press and hold the MENU button for at least 3 seconds to activate.
SENS - Sound sensitivity
1. Press the MENU button until "SENS" is displayed, press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust the sound sensitivity. 0 being
the least sensitive and 100 being the most sensitive. When you have found your desired setting press ENTER to
confirm.
BLND – Standby Mode
1. Press the MENU button until "BLND" is displayed, press ENTER. Either "YES" or "NO" will be displayed.
2. To activate the standby mode, press the UP or DOWN buttons until YES is displayed.
3. Press ENTER and hold the MENU button pressed for at least 3 seconds to confirm.
LED - Display back light
1. Press the MENU button until "LED" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to keep the LED display
on at all times, or "OFF" to switch to have the LED display switch off after 2 minutes.
3. Press ENTER and then press and hold the MENU button for at least three seconds to confirm.
Display Reverse 180°
1. Press the either the MENU button until "DISP" is displayed, press ENTER.
2. Press the UP button to select "YES" to reverse the display, or "NO" to change the display back.
3. Press ENTER to confirm.
Self test program
1. Press the MENU button until "TEST" is displayed, press ENTER.
2. The fixture will now run a self test. Press MENU to exit.
VER – Check the software version
LOAD – Restore to factory settings
1. Press the MENU button until "LOAD" is displayed. Press the ENTER button and the unit will reset itself.
©Copyright LOTRONIC 2017 DYNAMIC-LZR Page 5