afx light DYNAMIC-LZR Manuel D'utilisation page 3

Led moonflower gobo – wash – laser 3 en 1
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
Features
14/18 DMX channels
3 effects in 1: Gobo Effect, Strobe/Wash and Laser effect
8 x 3W RGBW LED's + 8 x 3W RGBA LED's + Red & Green Lasers
8 gobo patterns
9 light shows
Sound active, DMX, auto, master-slave and show mode
Strobe effect
IR remote control
Safety key for the laser
No duty cycles – Runs all night!
Specifications
Power supply ....................................................................................... 90-240Vac 50/60Hz
Consumption ............................................................................................................... 55W
Fuse ................................................................................................................................ 2A
Light sources ......................................... Gobo effect: 8 x 3W RGBW LED (2R, 2G, 2B, 2W)
.................................................... Wash/strobe effect: 8 x 3W RGBA LED (2R, 2G, 2B, 2A)
................................................................................................. Red laser 100mW (650nm)
.............................................................................................. Green laser 30mW (532nm)
Dimensions .......................................................................................... 400 x 200 x 150mm
Weight ...................................................................................................................... 3.72kg
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid
vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit is secure
and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that can hold 12 times
the weight of the unit when installing the fixture.
The equipment must be fixed by professionals at a place where is out of the reach of people and where nobody can
pass by or under it.
Fuse Replacement
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With a Phillips head screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact customer support for
further instructions. Continuing to use the unit may cause serious damage.
©Copyright LOTRONIC 2017
DYNAMIC-LZR
Page 3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

15-1880

Table des Matières