The timer is also a start programmer when the
appliance is in stand-by: every time the button
gets pressed the timer adds one hour of stand-
by, when the time runs out the appliance starts
automatically. The remaining time (in hours) is
written on the display until the time runs out and
the appliance starts to work.
•
The buttons
49°C); the default temperature is 23°C and it increases if you press the
and decreases if you press the
between the selected temperature nad the outside temperature and it can vary
between 1000W, 2000W or "only ventilation" mode: when the selected
temperature is reached the appliances stops automatically. If the appliance is in
Stand-by and the temperature decreases 2°C from the selected temperature the
program starts the appliance automatically. If the selected temperature is lower
than the room temperature the appliance will not work. To leave out the room
temperature press the
this mode without temperature limit. The symbol °C disappears from the display
and the symbol "- -" appears. The appliance will work for 12 hours at the
selected power, then it will work for 30 seconds as "only ventilation" and then go
into stand-by.
•
The
button on the remote control confirms the selected temperature or the
selected time.
Weekly program (only remote control)
•
The
button on the remote control: shows the "window sensor" that checks if
the temperature goes down by 5-10°C in less than 10 minutes and if it does it
stops the appliance for 30 minutes and then goes in stand-by.
•
The
button on the remote control: chooses the days of the week (d1-d7).
•
The
button on the remote control: activates the weekly program.
•
The
button on the remote control: selects the start time of the daily
program.
•
The
button on the remote control: activates the day program with a
maximum of 6 periods (P1-P6) .
.
and
on the remote control: define the temperature (10-
button and select power I or II: the appliance works in
button. The power depends on the difference
20
button