Bimar KPT-2000B 5208LE Notice D'instructions page 17

INSTALLATION
• After unpacking, check the integrity of the appliance; if in doubt, do not use it and
contact a qualified technician.The packaging materials (plastic bags, polystyrene,
metal staples, etc.) must not be left within reach of children, as they are potentially
hazardous.
• Before installing the appliance, make sure that:
- the electrical system to which the appliance will be connected complies with current
standards and has cables whose cross-section is suitable for the absorbed power
- the voltage values on the nameplate correspond to those on the mains supply.Check
that other appliances with high absorption are not connected to the power line to avoid
overloading and fire hazards.In the event of incompatibility between the power socket
and the appliance's plug, have the plug replaced with a suitable model by a qualified
professional, who should ensure that the cable is appropriate for the power rating of
the device.The use of adaptors or extensions is generally not advisable; if it is necessary
to use them, they must comply with safety regulations and the total current (amperes)
must not be rated lower than the maximum current of the appliance.
- There are no water, gas or power lines inside the wall
- The wall to which the appliance is to be fixed must be made of masonry and/or heat-
resistant, fire-retardant and solid material (not wood or synthetic material), flat and free
of irregularities; the ceiling must also be made of fire-retardant and heat-resistant
material.
- the appliance can be installed at least 2.0m from the ground (height referred to the
lower edge of the appliance), is positioned so that it cannot suffer impacts and that the
air outlet grid has a free space of at least 100cm, and at least 40cm at the sides.If
installed in a bathroom, in addition to the height from the ground, it must be ensured
that the switches and control devices cannot be touched or reached by a person in the
bathtub or shower.
- the appliance is away from other sources of heat, flammable materials (curtains,
upholstery, etc.), flammable gases or explosive materials (spray cans) and materials that
can be deformed by heat.
•
This appliance must not be used in any type of vehicle or restricted space (lifts,
camper vans, cars, cabins etc.).
• To install the appliance, proceed as follows and refer to the figures:
- The appliance must be fixed in such a way that it is horizontal and the air outlet grid
is on the underside.
- the fixing is provided by means of 2 screws that engage in the 2 "lock hole" slots made
on the rear panel.
17